Datalogic Gryphon I GBT4400 Product Reference Manual page 271

Table 36
STEP ACTION
1. Scan the ENTER/EXIT bar code
Determine placement of the
Label ID characters BEFORE or
AFTER with regard to scanned
2.
data using
Control, starting on page 77
Scan the bar code selecting
the symbology type you wish
to designate label ID
3. characters for using
Symbology Selection • 1D
Symbologies, starting on page
78.
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
ASCII Chart(inside back
cover), then scan in these
digits/characters using the bar
codes in the section:
Keypad, starting on page
5.
If you make a mistake before
the last character, scan the
CANCEL bar code to abort and
not save the entry string. You
can then start again at the
beginning.
6. Scan the ENTER/EXIT bar code
Scan the ENTER/EXIT bar code
7.
once again
Result:
Product Reference Guide
. Label ID Examples
Enable as Prefix
Label ID
DataBar
Label ID
Omnidirectional
D B *
307.
44 42 2A
DB*[bar code
data]
EXAMPLES
(Scanner enters Programming Mode)
Enable as Suffix Enable as Prefix
Code 39 Interleaved 2 of 5
= C 3 +
3D 43 33 2B
(Scanner exits Label ID entry)
(Scanner exits Programming Mode)
[bar code
+[bar code data]
data]=C3
Data Editing
Enable as Suffix
Code 32
P H
50 48
[bar code data]PH
267