Aztec Code Length Control; Aztec Code Set Length 1 - Datalogic Gryphon I GBT4400 Product Reference Manual

Aztec Code

Aztec Code Length Control

This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
Fixed Length:
DEFAULT
$CAZLC01(CR)
Aztec Code Length Control = Fixed Length

Aztec Code Set Length 1

Specifies one of the bar code lengths for
label length if in
Characters can be set from 0001 to 3,832 characters in increments of 0001 (pad with zeroes).
See page 259
$CAZL1
Select Aztec Code Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length may be set.
For fixed length decoding, two different lengths may be set.
Variable Length Mode, or the first fixed length if in Fixed Length Mode.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
$CAZLC00(CR)
Aztec Code Length Control = Variable Length
Aztec Code Length Control. Length 1 is the minimum
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
CANCEL
representing your
201