Pdf417 Length Control; Pdf417 Set Length 1 - Datalogic Gryphon I GBT4400 Product Reference Manual

PDF417

PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
Fixed Length:
DEFAULT
$CP4LC01(CR)
PDF417 Length Control = Fixed Length

PDF417 Set Length 1

Specifies one of the bar code lengths for
label length if in
Length includes the bar code's data characters only. Characters can be set from 0001 to 2,710
characters (pad with zeroes) in increments of 01. Any value greater than 2,710 will be
considered to be 2,710.
See page 259
$CP4L1
Select PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length may be set.
For fixed length decoding, two different lengths may be set.
Variable Length Mode, or the first fixed length if in Fixed Length Mode.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
$CP4LC00(CR)
PDF417 Length Control = Variable Length
PDF417 Length Control. Length 1 is the minimum
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
CANCEL
representing your
213