Datalogic Gryphon I GBT4400 Product Reference Manual page 270

References
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a bar code to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 18. Label ID Position Options
266
page 77 and scan the ENTER/EXIT bar code.
fix) by scanning the appropriate bar code in the section "Label ID Control" on page 77.
Reference Figure 18 for Label ID positioning options if multiple identification features are
enabled.
ID from the section "Label ID Symbology Selection • 1D Symbologies" on page 78.
Label ID for the selected symbology.
ASCII Chart
hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 307
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Prefix Label ID
on the inside back cover of this manual and find the equivalent
and scan the bar codes representing the hex characters deter-
Table 36.
Aim ID Bar Code Data
OR
Label ID Suffix
Gryphon™ I GD44XX/GBT4400