Source Radio Address Delimiter Character; Link Timeout - Datalogic QuickScan I QM21X1 Product Reference Manual

Enter/Exit Programming Mode

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
NOTE
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT

Link Timeout

This feature specifies the wait time in one-second ticks for response from the
remote. The selectable timeout range is 01 to 40 (01-0x28) seconds in one
second increments.
$CBTLT
Set Link Timeout
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
Product Reference Guide
This feature only applies if "Source Radio Address Transmis-
sion" on page 266 is enabled.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
00 = No Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
02 Link Timeout value is 2 seconds
Appendix D, Keypad
CANCEL
Appendix D, Keypad
~
CANCEL
representing your
representing your
267