Reading Parameters; Label Gone Timeout - Datalogic Gryphon I GBT4400 Product Reference Manual

Reading Parameters

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for a new
label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds (2.55
seconds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a
trigger pull for each label that is read
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Go to
4. Scan the bar code: SELECT LABEL GONE TIMEOUT SETTING.
5. Scan the appropriate three alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 37. Timeout Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
Product Reference Guide
ing zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.
page 88 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
Programming Mode.
pad representing the duration which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
50ms
005
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT LABEL GONE TIMEOUT SETTING
'0' , '0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Table 37 for some examples of how to set this feature.
EXAMPLES
150ms 1800ms (1.8 sec.)
015
'0' , '1' and '5' '1' , '8' and '0'
Reading Parameters
Appendix D, Key-
2550ms (2.55 sec.)
180 255
''2' , '5' and '5'
269