Aiming Duration Timer; Green Spot Duration - Datalogic Gryphon I GBT4400 Product Reference Manual

Enter/Exit Programming Mode

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 274
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.

Green Spot Duration

Specifies the duration of the good read pointer beam after a good read.
$CLSSP01(CR)
Green Spot Duration = Short (300 msec)
$CLSSP03(CR)
Green Spot Duration = Long (800 msec)
100
in "References" for a description of this feature.
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad
representing your desired char-
acter(s). End by scanning the ENTER/EXIT barcode.
~
CANCEL
$CLSSP00(CR)
Green Spot Duration = Disable (Green Spot is Off )
DEFAULT
$CLSSP02(CR)
Green Spot Duration = Medium (500 msec)
Gryphon™ I GD44XX/GBT4400