Enter/Exit Programming Mode
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
This feature only applies if
page 221 is enabled.
$CBTAD
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Link Timeout
This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See
page 236
for more information on setting this feature.
$CBTLT
Set Link Timeout
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
222
DEFAULT
02 Link Timeout value is 2 seconds
DEFAULT
"Source Radio Address Transmission"
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D Keypad
acter(s). End by scanning the ENTER/EXIT bar code again.
~
00 = No Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
QuickScan™ I QD24XX/QBT24XX/QM24XX
RF Address Stamping
on
representing your desired char-
CANCEL
representing your
CANCEL