Datalogic Gryphon I GBT4400 Product Reference Manual page 254

References
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT ACK CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
See Table 26
Table 26. ACK Character Setting Examples
STEP ACTION
1 Desired Character/Value
Hex equivalent from
2
Chart
3
4
Scan Two Characters from
5
Appendix D, Keypad
6
250
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters. 8-bit data is not
recognized when the option
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
page 48 and scan ENTER/EXIT PROGRAMMING MODE to enter Program-
ming Mode.
pad, that represent the desired character/value in step 1 above. The second character will
cause a two-beep indication.
for some examples of how to set this feature.
ACK
ASCII
0x06
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT ACK CHARACTER SETTING
'0' and '6'
Scan ENTER/EXIT PROGRAMMING MODE
Data Bits
has been set as 7 Data Bits.
EXAMPLES
$ @
0x24 0x40
'2' and '4' '4' and '0'
Gryphon™ I GD44XX/GBT4400
Appendix D, Key-
>
0x3E
'3' AND 'E'