Source Radio Address Delimiter Character; Link Timeout - Datalogic Gryphon I GBT4400 Product Reference Manual

Enter/Exit Programming Mode

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
$CBTAD
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
DEFAULT

Link Timeout

This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See page 258
$CBTLT
Set Link Timeout
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
DEFAULT
244
This feature only applies if "Source Radio Address Transmission" on
page 243 is enabled.
for more information on setting this feature.
02 Link Timeout value is 2 seconds
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D. Keypad
characters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
CANCEL
00 = No Delimiter Character
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X
RF Address Stamping
representing your
Appendix D. Keypad