Global Prefix/Suffix - Datalogic Gryphon I GBT4400 Product Reference Manual

Enter/Exit Programming Mode

Global Prefix/Suffix

This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the bar code data, also
called a header) and/or as a suffix (in a position following the bar code data, also called a footer).
See page 261
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code above
to place the unit in Programming Mode, then the "Set Global Prefix" or "Set Global Suffix,"
bar code followed by the digits (in hex) from the Alphanumeric characters in
Keypad
are selected, scan the ENTER/EXIT bar code to terminate the string. Exit programming mode
by scanning the ENTER/EXIT bar code again.
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
72
for more detailed instructions on setting this feature.
representing your desired character(s). If less than the expected string of 20 characters
DEFAULT
$CLFPR
Set Global Prefix
~
No Global Prefix
Global Suffix = 0x0D (CR)
Global Prefix/Suffix
Appendix D,
CANCEL
Gryphon™ I GD44XX/GBT4400