Interface Selection; Setting The Interface - Datalogic Gryphon I GBT4400 Product Reference Manual

Interface Selection

Upon completing the physical connection between the reader and its host, proceed to Table 1
starting on page 28
Keyboard Wedge, USB, etc.). Scan the appropriate bar code in that section to configure your
system's correct interface type.
Each reader model will support one of the following sets of host interfaces:
General Purpose Models
•
•
•
•
•

Setting the Interface

Scan the programming bar code from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding
section in this manual (also listed in Table
settings and features associated with that interface.
Product Reference Guide
to select the interface type the reader is connected to (for example: RS-232,
RS-232
RS-232 OPOS
USB-COM
Keyboard Wedge
Wand Emulation (BT only)
Unlike some programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT
scan an ENTER/EXIT bar code prior to scanning an interface selection bar
code.
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will
change to a state that allows programming with bar codes.
Retail Point of Sale Models
• RS-232
• RS-232 OPOS
• USB
• IBM 46XX
1starting on page 28) to configure any desired
Interface Selection
27