Viewing The Current Instrumentation Monitor Configuration - HP 3500yl Series Access Security Manual

Configuring Advanced Threat Protection
Using the Instrumentation Monitor
# show instrumentation monitor configuration
HP Switch
PARAMETER
------------------------- ---------------
mac-address-count
ip-address-count
system-resource-usage
system-delay
mac-moves/min
learn-discards/min
ip-port-scans/min
arp-requests/min
login-failures/min
port-auth-failures/min
SNMP trap generation for alerts: enabled
Instrumentation monitoring log : enabled
Figure 11-10. Viewing the Instrumentation Monitor Configuration
11-38
Viewing the Current Instrumentation Monitor
Configuration
The show instrumentation monitor configuration command displays the config-
ured thresholds for monitored parameters.
LIMIT
1000 (med)
1000 (med)
50 (med)
5 (high)
100 (med)
100 (med)
10 (med)
100 (low)
10 (med)
10 (med)
An alternate method of determining the current Instrumentation Monitor
configuration is to use the show run command. However, the show run com-
mand output does not display the threshold values for each limit set.