The following table describes the labels in this screen.
Table 150 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
Port
Management
Address
Port Description
System
Capabilities
System
Description
System Name
Apply
Cancel
34.6.2 LLDP Configuration Basic Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click Advanced Application >
LLDP > LLDP Configuration > Org-specific TLV Setting to display the screen as shown next.
Figure 188 Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
Chapter 34 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This displays the port number on which you're configuring LLDP. Select check boxes in
the * row to configure all ports simultaneously. All check boxes below * row are enabled
by default.
Select check box to enable or disable the sending of Management Address TLVs on the
port(s).
Select check box to enable or disable the sending of Port Description TLVs on the port(s).
Select check box to enable or disable the sending of System Capabilities TLVs on the
port(s).
Select check box to enable or disable the sending of System Description TLVs on the
port(s).
Select check box to enable or disable the sending of System Name TLVs on the port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
290