ZyXEL Communications GS3700 Series User Manual page 234

The following table describes the labels in this screen.
Table 117 IP Source Guard > ARP Inspection VLAN Configure
LABEL DESCRIPTION
VLAN Use this section to specify the VLANs you want to manage in the section below.
Start VID Enter the lowest VLAN ID you want to manage in the section below.
End VID Enter the highest VLAN ID you want to manage in the section below.
Apply Click this to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure
the * VLAN, the settings are applied to all VLANs.
Enabled Select Yes to enable ARP inspection on the VLAN. Select No to disable ARP inspection on
the VLAN.
Log Specify when the Switch generates log messages for receiving ARP packets from the
VLAN.
None: The Switch does not generate any log messages when it receives an ARP packet
from the VLAN.
Deny: The Switch generates log messages when it discards an ARP packet from the
VLAN.
Permit: The Switch generates log messages when it forwards an ARP packet from the
VLAN.
All: The Switch generates log messages every time it receives an ARP packet from the
VLAN.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Chapter 24 IP Source Guard
GS3700/XGS3700 Series User's Guide
234