Spanning Tree Configuration - ZyXEL Communications GS3700 Series User Manual

Figure 69 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.

11.3 Spanning Tree Configuration

Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 70 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 43 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
Chapter 11 Spanning Tree Protocol
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning
Tree. See Section 11.1 on page 106
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
111
for background information on STP.