ZyXEL Communications GS3700 Series User Manual page 300

Figure 195 IP Application > Static Routing > IPv6 Static Route
The following table describes the related labels you use to create a static route.
Table 156 IP Application > Static Routing > IPv6 Static Route
LABEL DESCRIPTION
Route Enter the IPv6 address of the final destination.
Destination
Prefix Length Enter the prefix length number of up to 64 for this destination.
Next Hop Enter the IPv6 address of the next-hop router.
Interface Type Select the type of the IPv6 interface through which the IPv6 packets are forwarded.
The Switch supports only the VLAN interface type at the time of writing.
Interface ID Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.
Add Click Add to insert a new static route to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This field displays the index number of the route. Click a number to edit the static route
entry.
Interface This field displays the descriptive name of the interface that is used to forward the packets
to the destination.
Route This field displays the IPv6 subnet prefix and prefix length of the final destination.
Destination/
Prefix Length
Next Hop This field displays the IPv6 address of the gateway that helps forward the packet to the
destination.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Chapter 35 Static Route
GS3700/XGS3700 Series User's Guide
300