Enabling/Disabling Sending Of Snmp Traps On A Port - ZyXEL Communications GS3700 Series User Manual

43.3.6 Enabling/Disabling Sending of SNMP Traps on a Port

From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to
set whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 249 Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Table 195 Management > Access Control > SNMP > Trap Group > Port
LABEL
Option
Port
*
Active
Apply
Cancel
Chapter 43 Access Control
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
360