Configuring Snmp Trap Group - ZyXEL Communications GS3700 Series User Manual
Gbe l2+ switch
Hide thumbs
Also See for GS3700 Series:
- User manual (549 pages) ,
- Cli reference manual (361 pages) ,
- Handbook (215 pages)
Table of Contents
Advertisement
Table 193 Management > Access Control > SNMP (continued)
LABEL
Apply
Cancel
43.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group
screen to specify the types of SNMP traps that should be sent to each SNMP manager.
Figure 248 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 194 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination
IP
Type
Options
Apply
Cancel
Chapter 43 Access Control
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Section 43.3.3 on page 354
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category's check box automatically clears
all of the category's trap check boxes (the Switch only sends traps from selected
categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
359
for individual trap descriptions.
Advertisement
Table of Contents
