ZyXEL Communications GS3700 Series User Manual page 372

Figure 263 Management > Access Control > Remote Management
The following table describes the labels in this screen.
Table 199 Management > Access Control > Remote Management
LABEL DESCRIPTION
Entry This is the client set index number. A "client set" is a group of one or more "trusted
computers" from which an administrator may use a service to manage the Switch.
Active Select this check box to activate this secured client set. Clear the check box if you wish to
temporarily disable the set without deleting it.
Start Address Configure the IP address range of trusted computers from which you can manage this
Switch.
End Address
The Switch checks if the client IP address of a computer requesting a service or protocol
matches the range set here. The Switch immediately disconnects the session if it does not
match.
Telnet/FTP/ Select services that may be used for managing the Switch from the specified trusted
HTTP/ICMP/ computers.
SNMP/SSH/
HTTPS
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 43 Access Control
GS3700/XGS3700 Series User's Guide
372