Tacacs+ Server Setup - ZyXEL Communications GS3700 Series User Manual
Gbe l2+ switch
Hide thumbs
Also See for GS3700 Series:
- User manual (549 pages) ,
- Cli reference manual (361 pages) ,
- Handbook (215 pages)
Table of Contents
Advertisement
Table 97 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
23.2.2 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See
more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
Chapter 23 AAA
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
The default port of a RADIUS accounting server for accounting is 1813. You need not
change this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external RADIUS accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external RADIUS accounting server and the
Switch.
Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
203
Section 23.1.2 on page 201
for
Advertisement
Table of Contents
