Ipv6 Router Discovery Setup - ZyXEL Communications GS3700 Series User Manual

Figure 39 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup
The following table describes the labels in this screen.
Table 24 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup
LABEL
Interface
DAD Attempts
NS Interval
Reachable Time
Apply
Cancel
Clear
Index
Interface
DAD Attempts
NS Interval
Reachable Time

6.9.8 IPv6 Router Discovery Setup

Use this screen to configure router discovery settings for each interface. Click the link next to IPv6
Router Discovery Setup in the IPv6 Configuration screen to display the screen as shown next.
Chapter 6 Basic Setting
DESCRIPTION
Select the IPv6 interface you want to configure.
The Switch uses Duplicate Address Detection (DAD) with neighbor solicitation and
advertisement messages to check whether an IPv6 address is already in use before
assigning it to an interface, such as the link-local address it creates through stateless
address autoconfiguration.
Specify the number of consecutive neighbor solicitations (from 0 to 600) the Switch
sends for this interface. Enter 0 to turn off DAD.
Specify the time interval (from 1000 to 3600000 milliseconds) at which neighbor
solicitations are re-sent for this interface.
Specify how long (from 1000 to 3600000 milliseconds) a neighbor is considered
reachable for this interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays the number of consecutive neighbor solicitations the Switch sends
for this interface.
This field displays the time interval (in milliseconds) at which neighbor solicitations are
re-sent for this interface.
This field displays how long (in milliseconds) a neighbor is considered reachable for
this interface.
GS3700/XGS3700 Series User's Guide
75