ZyXEL Communications GS3700 Series User Manual page 40

Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify
and authenticate a PPPoE client.
Errdisable This link takes you to a screen where you can configure CPU protection and error disable
recovery.
MAC Pinning This link takes you to a screen where you can set specific ports to have priority over other
ports in MAC address learning.
Private VLAN This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
Green Ethernet This link takes you to a screen where you can configure the Switch to reduce port power
consumption.
LLDP This link takes you to a screen where you can configure LLDP settings.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
Policy Routing This link takes you to screens where you can configure policy routing rules.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
VRRP This link takes you to screens where you can configure redundant virtual router for your
network.
Load Sharing This link takes you to a screen where you can enable Equal-Cost MultiPath (ECMP) routing
and set the criteria the Switch uses to determine the routing path for a packet.
ARP Setup This link takes you to a screen where you can configure ARP learning mode on a per-port
basis and create static ARP entries which do not age out.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and
configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and can test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log server.
Cluster This link takes you to a screen where you can configure clustering management and view
Management its status.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attach to a port. You can also view what kind of MAC address it is.
IP Table This link takes you to a screen where you can view the IP addresses and VLAN ID of a
device attached to a port.You can also view what kind of device it is.
ARP Table This link takes you to a screen where you can view the MAC address – IP address
resolution table.
Routing Table This link takes you to a screen where you can view the routing table.
Path MTU Table This link takes you to a screen where you can view the IPv6 path MTU table.
Configure Clone This link takes you to a screen where you can copy attributes of one port to (an)other
port(s).
Neighbor Table This link takes you to a screen where you can view the Switch's IPv6 neighbor table.
Chapter 4 The Web Configurator
GS3700/XGS3700 Series User's Guide
40