Mld Snooping-Proxy Filtering - ZyXEL Communications GS3700 Series User Manual

Table 91 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port
Role Setting (continued)
LABEL
Leave Timeout
Fast Leave
Timeout
Apply
Cancel

22.4.4 MLD Snooping-proxy Filtering

Use this screen to configure the Switch's MLD filtering settings. Click the MLD Snooping-proxy
link and then the Filtering link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See
multicasting.
Figure 119 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Chapter 22 Multicast
DESCRIPTION
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
GS3700/XGS3700 Series User's Guide
190
Section 22.1 on page 177 for more information on