Lldp-Med Configuration - ZyXEL Communications GS3700 Series User Manual

The following table describes the labels in this screen.
Table 151 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Port
Dot1 TLV
Port-Protocol
VLAN ID
Port VLAN ID
Dot3 TLV
Link
Aggregation
MAC/PHY
Max Frame
Size
Power Via MDI
Apply
Cancel

34.7 LLDP-MED Configuration

Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown
next.
Chapter 34 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This displays the port number on which you're configuring LLDP. Select check boxes in
the * row to configure all ports simultaneously.
Select check box to enable or disable the sending of IEEE 802.1 Port and Protocol VLAN
ID TLVs on the port(s).
Select check box to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on the
port(s). All check boxes in this column are enabled by default.
Select check box to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs on
the port(s).
Select check box to enable or disable the sending of IEEE 802.3 MAC/PHY Configuration/
Status TLVs on the port(s). All check boxes in this column are enabled by default.
Select check box to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs on
the port(s).
Note: For PoE models only.
The Power Via MDI TLV allows network management to advertise and discover the MDI
power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
• MDI Enabled
• Pair Controlable
• PSE Power Pairs
• Power Class
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
291