Igmp Filtering Profile - ZyXEL Communications GS3700 Series User Manual

The following table describes the labels in this screen.
Table 86 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Snooping
VLAN
LABEL
Mode
Apply
Cancel
VLAN
Name
VID
Add
Cancel
Clear
Index
Name
VID
Delete
Cancel

22.3.3 IGMP Filtering Profile

An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch
are able to join. A profile contains a range of multicast IP addresses which you want clients to be
able to join. Profiles are assigned to ports (in the IGMP Snooping screen). Clients connected to
those ports are then able to join the multicast groups specified in the profile. Each port can be
assigned a single profile. A profile can be assigned to multiple ports.
Click Advanced Application > Multicast > IPv4 Multicast in the navigation panel. Click the
IGMP Snooping link and then the IGMP Filtering Profile link to display the screen as shown.
Chapter 22 Multicast
DESCRIPTION
Select auto to have the Switch learn multicast group membership information of any
VLANs automatically.
Select fixed to have the Switch only learn multicast group membership information of the
VLAN(s) that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs (including up to five
VLANs you configured in the MVR screen). For example, if you have configured one
multicast VLAN in the MVR screen, you can only specify up to 15 VLANs in this screen.
The Switch drops any IGMP control messages which do not belong to these 16 VLANs.
Note: You must also enable IGMP snooping in the Multicast > IPv4 Multicast > IGMP
Snooping screen first.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section of the screen to add VLANs upon which the Switch is to perform IGMP
snooping.
Enter the descriptive name of the VLAN for identification purposes.
Enter the ID of a static VLAN; the valid range is between 1 and 4094.
Note: You cannot configure the same VLAN ID as in the MVR screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Click Clear to reset the fields to the factory defaults.
This is the index number of the IGMP snooping VLAN entry in the table. Click on an index
number to view more details or change the settings.
This field displays the descriptive name for this VLAN group.
This field displays the ID number of the VLAN group.
Check the entry(ies) that you want to remove in the Delete column, then click the
Delete button.
Click Cancel to clear the Delete check boxes.
GS3700/XGS3700 Series User's Guide
184