Port-Based Vlan Setup; Configure A Port-Based Vlan - ZyXEL Communications GS3700 Series User Manual
Gbe l2+ switch
Hide thumbs
Also See for GS3700 Series:
- User manual (549 pages) ,
- Cli reference manual (361 pages) ,
- Handbook (215 pages)
Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 36 Advanced Application > VLAN > Private VLAN Status
LABEL
Private VLAN
Status
Primary
VLAN
Secondary
VLAN
Type
Port List
Change Pages
7.6 Port-based VLAN Setup
Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish
to allow two subscriber ports to talk to each other, for example, between conference rooms in a
hotel, you must define the egress (an egress port is an outgoing port, that is, a port through which
a data packet leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as IP Setup and Filtering) that require a VID, you must enter 1
as the VID.
The port-based VLAN setup screen is shown next. The CPU management port forms a VLAN with all
Ethernet ports.
7.6.1 Configure a Port-based VLAN
Select Port Based as the VLAN Type in the Switch Setup screen and then click VLAN from the
navigation panel to display the following screen. Select either All Connected or Port Isolated
from the drop-down list depending on your VLAN and VLAN security requirements. If VLAN
members need to communicate directly with each other, then select All Connected. Select Port
Isolated if you want to restrict users from communicating directly. Click Apply to save your
settings.
The following screen shows users on a port-based, all-connected VLAN configuration.
Chapter 7 VLAN
DESCRIPTION
These fields show information for the all private VLANs. See also Advanced Application >
Private VLAN.
This field shows the primary VLAN ID in a private VLAN.
This field shows the secondary VLAN ID in a private VLAN.
This field shows the type of private VLAN: Primary, Community or Isolated.
This shows the ports mapped to the private VLAN using the Advanced Application >
Private VLAN or Advanced Application > VLAN > Static VLAN screen.
Use the Previous and Next buttons to display different pages.
GS3700/XGS3700 Series User's Guide
95
Advertisement
Table of Contents
