Vrrp Status; Vrrp Configuration; Ip Interface Setup - ZyXEL Communications GS3700 Series User Manual

39.2 VRRP Status

Click IP Application > VRRP in the navigation panel to display the VRRP Status screen as shown
next.
Figure 220 IP Application > VRRP Status
The following table describes the labels in this screen.
Table 175 IP Application > VRRP Status
LABEL
Index
Network
VRID
VR Status
Uplink Status
Poll Interval(s)
Stop

39.3 VRRP Configuration

The following sections describe the different parts of the VRRP Configuration screen.

39.3.1 IP Interface Setup

Before configuring VRRP, first create an IP interface (or routing domain) in the IP Setup screen
(see the Section 6.5 on page 58
Chapter 39 VRRP
DESCRIPTION
This field displays the index number of a rule.
This field displays the IP address and the subnet mask bits of an IP routing domain that is
associated to a virtual router.
This field displays the ID number of the virtual router.
This field displays the status of the virtual router.
This field is Master indicating that this Switch functions as the master router.
This field is Backup indicating that this Switch functions as a backup router.
This field displays Init when this Switch is initiating the VRRP protocol or when the Uplink
Status field displays Dead.
This field displays the status of the link between this Switch and the uplink gateway.
This field is Alive indicating that the link between this Switch and the uplink gateway is up.
Otherwise, this field is Dead.
This field displays Probe when this Switch is check for the link state.
The text box displays how often (in seconds) this screen refreshes. You may change the
refresh interval by typing a new number in the text box and then clicking Set Interval.
Click Stop to halt system statistic polling.
for more information).
GS3700/XGS3700 Series User's Guide
328