Printing Result Obtained By Specifying A Character Alignment Mode And A Multiple Line Centering Mode - Partex PROMARK T-800 User Manual

4
Input characters.
Input "A-123", press [
Perform the printing operation.
Only 1.3mm double-byte characters can be set to three lines.
Note
The maximum number of printable characters depends on segment length setting.
While printing on self-adhesive labels, when the cutting option is on and the length of the marker is
set to 3 mm or less, there is a possibility that the cuts may coincide with the printed text. If you would
like to print short markers without cuts, press [Half cut] and then choose [No].
If you wish to increase the number of printable characters
Note
When "Normal" is selected on the Plate Printing Area selection display, spaces are automatically inser-
ted at the left and right of the print. When "Expansion" is selected, the printing area expands all over
the segment length without inserting any space.
If you wish to adjust the segment length
Note
For how to adjust the printing result finely, refer to Note, "Adjusting the segment length" (
Printing result obtained by specifying a character alignment mode and a multiple line
centering mode
The printing result varies depending on the choice of a character alignment mode and a multiple line centering mode.
Input characters
1st line A-123
2nd line: R11
CASE 1
Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2 mm/1-byte, Number of lines = 2 lines,
Character alignment = Centered, Multiple line centering = On
CASE 2
Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2 mm/1-byte
Number of lines = 2 lines, Character alignment = Centered, Multiple line centering = Off
CASE 3
Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2mm/1-byte,
Number of lines = 2 lines, Character alignment = Left/2 mm
112
] , and then input "R11".
page 101).
A-123