Partex PROMARK T-800 User Manual page 51

Attaching the wrap-around tape
1
Peel the printed film from the wrap around tape
backing.
When wrapping, the laminating cover should overlap the
printed part sufficiently. We therefore recommend using with
cable of →3 to →7.6 mm.
2
Attach the tape to the cable as shown in the dia-
gram, starting from the printed end.
3
Wrap the transparent laminating portion so that
it covers the printed part.
If the film does not peel away from the backing
Because wrap around tape has a strong adhesive, it may be hard to peel the film off the backing.
Refer to the following diagram for the peeling method.
Peel-off Film
If the cut is too shallow
Wrap around tape is thicker than typical label tape, so the half-cut may be shallower.
In this case, refer to "What To Do If the Cutter Is Getting Blunt" on page 130 to adjust cutting depth.
If it still does not cut, replace with new cutter.
If the half-cut is too shallow, the film may not peel from the backing properly.
Nisca Corporation shall not be responsible for damages that might result from
CAUTION
the tape peeling off, or from fading of the printing on the tape.
Printable Area
If this part is joined, pull apart with
your fingers
If the remaining part cannot be
separated adjust the cutting depth.
Basic Operations
Hold the backing
Peel the printed part away
Printable
Area
PART 2
47 47