Actions To Take Against Other Jams (When The "Media Jam" Message Is Not Displayed) - Partex PROMARK T-800 User Manual

Actions to Take against Other Jams (When the "Media JAM" message is not displayed)

The tube or tape may wind itself around the roller inside the printer when it is ejected improperly after printing or it is
improperly fed after replacement. If you happen to turn off the printer after "Media JAM" message is displayed and as a
consequence you cannot clear the jam according to the messages, you can remove the jammed printing media using
the Feed function in the maintenance mode.
1
When the printer is operating (printing), keep pres-
sing the [Canc] key until a "peep" sound is heard.
If the printer is not powered, turn it on.
2
Open the cover.
3
Remove the ribbon cassette from the printer.
If the ribbon winds itself around some parts inside the printer and
therefore the ribbon cassette cannot be removed, proceed to
step 4 without removing it.
4
Remove the label tape if it is loaded.
If the label tape winds itself around some parts and therefore it
cannot be removed, proceed to step 5 without removing it.
5
Close the cover.
6
Press the [Maint] key.
A function selection display appears.
126