Table of Contents
Advertisement
Print
Step 2
Once the characters have been input, begin printing.
1
Press [Print].
The print media selection display appears.
"No ribbon cassette" is displayed if the ribbon cassette is not installed. In-
stall the ribbon cassette.
"No ribbon information. No ribbon amount displayed. Press enter" is display-
ed if the information cannot be read due to the ribbon cassette failure and
so forth. If this message is displayed, follow the instruction on the screen.
What is "print media"?
Printed media are materials on which the printer prints: PO/POZ profile,
PHZ/PHZF heatshrinkable tubes, PP profile, self-adhesive label, self-lamina-
ting label etc.
2
Press [
] or [
The plate (width) selection display appears.
The plate size must be set accurately. If the correct plate size is not selected,
printing will not proceed correctly. (
3
Press [
] or [
The sets to print and range setting display appears.
If "Range: All" is not selected, press [
[
] or [
] to select "All".
Rough amount of the remaining ink ribbon is displayed as shown. When the
information of the cassette is not properly retrieved, the amount of the ribbon
does not appear.
4
Press [Enter].
Printing begins.
Canceling printing
If you press [Canc], the message "Aborting print" appears and printing is abor-
ted.
5
Take out the plate.
Cut the plate with scissors.
If a plate jams
Hold down [Canc] until the printer beeps. The printer stops all operations
immediately. Refer to "If a Tube or Label Tape Becomes Jammed" (
page 124) and take out the jammed plate.
] to select "PP" and then press [Enter].
page 152).
] to select "PP-090" and then press [Enter].
] or [
] to select "Range", then press
PART 2
Basic Operations
A check mark
is displayed next to
the currently selected print media.
A check mark
is displayed next to
the currently selected plate size.
If CL is displayed, a centerline is
printed.
55
55
Hide quick links:
Advertisement
Table of Contents
