Replacing The Cutter - Partex PROMARK T-800 User Manual

5.3 Replacing the Cutter

If tube or label tape is not fully separated even with forced full cutting (
When replacing the cutter, be sure to replace the cutter receiver at the same time. Contact your nearest dealer for details
on how to obtain a replacement cutter.
If half cuts are too deep even though the cutting depth has been adjusted to the shallowest level, it is possible that the
cutter receiver is worn.
Follow procedures!
The cutter is designed so that you cannot touch it directly, but it is possible that mishandling could expose
the blade, creating a risk of injury. Do not attempt any operation that is not described in this manual. Fur-
thermore, be sure to carefully follow the procedures described in this manual.
Dispose of the old cutter immediately
Do not keep the old cutter after you have replaced it; dispose of it right away. The cutter poses a risk of injury
to small children, etc.
Discard the removed cutter immediately in compliance with local regulations regarding the disposal of such
items.
1
Turn the power switch off.
Press the "O" side.
2
Open the cover.
Push the cover handle to the left and open the cover.
3
Pull out the cutter.
Dispose of the old cutter right away. When disposing of the cut-
ter, do not touch it anywhere other than where indicated in the
figure.
Maintenance
page 131) the cutter should be replaced.
PART 5
133 133