Partex PROMARK T-800 User Manual page 106

4
Segment length and character alignment screen display
The segment length and character alignment settings can be confirmed on display.
When segment length setting is "Automatic"
When "Specify" is selected on the Seg Length
selection display and "Normal" is selected
on the Plate Printing Area selection display
When "Specify" is selected on the Seg Length
selection display and "Expansion" is selected
on the Plate Printing Area selection display
Use [
102
Press [ ] or [ ] to select the adjust-ment va-
lue, and then press [Enter].
The correction value can be specified with the [+] or [-] key
and numeric keys.
You can input a correction value for negative correction. Ho-
wever, if there is no correction space (part other than cha-
racters), no more correction can be made.
The minimum unit of correction which is handled internally
is 0.085 mm.
If you input the wrong number by mistake, press [Back Spa-
ce] to delete the number and then input the correct number.
] or [ ] to set values to the right of the decimal point when setting the label length.
segment length
The setting is highlighted
P u m p R o o m
„C" when centered, „L" when left-aligned
segment length
P u m p R o o m
„C" when centered, „L" when left-aligned
segment length
P u m p R o o m
Always centered "C"
Margin
„E" when „Expansion"
is selected"