Printing A Specific Page Multiple Times (Continuous Print) - Partex PROMARK T-800 User Manual

Printing a specific page multiple times (Continuous Print)

Assume that you want to produce the following tube segments.
The number of continuous printings can be set from 1 to 100 for each page.
Fig. 1
Pump Room
In this case, it might seem acceptable to create the character data shown below, but what if you wanted to print 20 tube
segments labeled "Pump Room" instead of three? Not only would creating 20 pages with the "Pump Room" character
data take a lot of time, it would also use a lot of memory.
Fig. 2
Pump Room
(page 1) (page 2)
In a case such as that shown in Fig. 1, you can obtain the same results by creating the character data shown below and
then printing page 2 ("Pump Room") three times. The function that prints multiple copies of a specific page is called
"Continuous Print".
Fig. 3
Pump Room
(page 1) (page 2)
Print this page three times
ex. Produce the tubes shown in Fig. 1.
1
Input the character data shown in Fig. 3.
2
Display the page for which you wish to use conti-
nuous print.
Press [Shift] + [ ] or [Shift] + [
"Pump Room" has been input.
3
Press [Cont Print].
The continuous print selection display appears.
Pump Room Pump Room
Pump Room Pump Room
(page 3) (page 4)
(page 3)
] and display the page in which
(page 5)
PART 4
Advanced Operations
Pump Room
103 103