Partex PROMARK T-800 User Manual page 99

ex. Create the character data shown below and then use that data to produce tube segments as
shown in the example below by printing the character data from pages 2 to 4 as follows.
Pump Room
(page 1) (page 2)
Print this scope three times
Output Example
Pump Room
Pump Room
Pump Room
1
Press [Print].
The Print Media selection display appears.
2
Press [ ] or [
[Enter].
The Tube size selection display appears.
3
Press [ ] or [
press [Enter].
The Sets to print and Range setting display appears.
4
Press [ ] or [
press [3].
If you input the wrong number by mistake, press [Back Space] to
delete the number and then input the correct number.
(page 3) (page 4)
1 st time
2 nd time
3 rd time
] to select "PHZ" and then press
] to select "PHZ 4.8 mm" and then
] to select "Sets to print" and then
(page 5)
Advanced Operations
A check mark is displayed next to
the currently selected print media.
A check mark is displayed next to
the currently selected print media.
PART 4
95 95