Cleaning The Print Head; Cleaning/Replacing The Tube Cleaner For Attachment - Partex PROMARK T-800 User Manual

Cleaning the print head

Use a cotton swab to clean dirt from the print head. Be very careful not
to scratch the head. Also, always be sure to turn the power switch off
before beginning to clean the print head. If the print head is extremely
dirty, place a few drops of water on the cotton swab, and then wipe the
dirt away. Never use alcohol, benzene, or other solvents. Such chemi-
cals could damage the unit.
Print head

Cleaning/Replacing the tube cleaner for attachment

The attachment has a cleaner that removes dirt from the surface of
media.
Remove the cleaner as shown in the illustration, and then clean the
sponge to remove accumulated dirt.
When the sponge becomes damaged, replace the cleaner.
Contact your nearest dealer to purchase replacement tube cleaners.
Cleaner
Sponge
140