Partex PROMARK T-800 User Manual page 3

When you open a power distribution panel, you are confronted with an array of tightly packed terminals, circuit breakers,
and switches, and these myriad devices are connected by a maze of cables. If each device and cable is not clearly labeled
with a symbol or a number, maintenance can become a nightmare. In such electrical facilities, it is common practice to
use printed tube to identify cables and printed labels to identify switches. The printer is used to print such labels and tube.
We wish you successful work with the printer.
Tube
Print of the profiles
for wires and cables.
T-800 prints on: PO profile
for the wires from 0.25 to
6.00 mm, their halogen-free
version POZ, halogen-free
heatshrinkable tubes PHZ,
PP profile which can be in-
serted in PT, PT+, PTC, PTZ+
holders, PM and PTM profile,
cable profile PO-068.
Use only the materials and settings recommended by Partex Marking Systems. Using other materials
could cause a damage to the printer and consequently, to the loss of the warranty.
PROFESSIONAL PORTABLE PRINTER
OF PROFILES – PROMARK T-800
Label
Start
Clear marking system
Labels' print
PROMARK T-800 also prints
on self-adhesive labels (pro-
vided separately). With the
labels of different width you
can mark
lves, buttons or other com-
ponents for cable cabinets.
THE PRODUCER'S WARRANTY
For the list of markers for printing go to pages 142-145.
For the recommended font settings, go to page 154.
laminate seal
Labeled with switch
name or number
connectors, va-
Clear
Label with clear adhesive
lamination
Wrap around tape
with printable and
laminating layers
When applied after print-
ing, the printing is covered
by plastic laminating film,
protecting the characters
from scratching. Adheres to
cables after they have been
connected.