V Protocol Vlan Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete Settings button to remove the Protocol for the Protocol VLAN Group information for the specific
entry.
Click the Delete Group button to remove the entry completely.
NOTE: The Group name value should be less than 33 characters.

802.1v Protocol VLAN Settings

The user can configure Protocol VLAN settings. The lower half of the table displays any previously created settings.
To view the following window, click L2 Features > VLAN > 802.1v protocol VLAN > 802.1v Protocol VLAN
Settings, as show below:
The fields that can be configured are described below:
Parameter
Group ID
Group Name
VID (1-4094)
VLAN Name
802.1p Priority
octet string will have one of the following values: For Ethernet II, this is a 16-bit (2-octet)
hex value. For example, IPv4 is 800, IPv6 is 86dd, ARP is 806, etc. For IEEE802.3 SNAP,
this is a 16-bit (2-octet) hex value. For IEEE802.3 LLC, this is a 2-octet IEEE 802.2 Link
Service Access Point (LSAP) pair. The first octet is for Destination Service Access Point
(DSAP) and the second octet is for Source.
Figure 4-9 802.1v Protocol VLAN Settings window
Description
Select a previously configured Group ID from the drop-down menu.
Select a previously configured Group Name from the drop-down menu.
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user wishes
to create.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user wishes
to create.
This parameter is specified if you want to re-write the 802.1p default priority previously set
in the Switch, which is used to determine the CoS queue to which packets are forwarded
to. Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
Click the corresponding box if you want to set the 802.1p default priority of a packet to the
value entered in the Priority (0-7) field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will
72