D-Link xStack DGS-3420 Series Reference Manual page 239

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID (1-4)
Profile Name
Select ACL Type
IPv6 Class
IPv6 TCP
IPv6 UDP
ICMP
IPv6 Source Mask
IPv6 Destination Mask
Figure 7-59 Add Egress ACL Profile window (IPv6 ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to
4.
Enter a profile name for the profile created.
Select profile based on Ethernet (MAC Address), IPv4 address, or IPv6 address.
This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each
packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each
frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each
frame's header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of
Service (ToS) or Precedence bits field in IPv4.
Source Port Mask – Specify that the rule applies to the range of TCP source ports.
Destination Port Mask – Specify the range of the TCP destination port range.
Source Port Mask – Specify the range of the UDP source port range.
Destination Port Mask – Specify the range of the UDP destination port mask.
Select ICMP to instruct the Switch to examine the Internet Control Message
Protocol (ICMP) field in each frame's header.
The user may specify an IPv6 address mask for the source IPv6 address by
ticking the corresponding check box and entering the IPv6 address mask, e.g.
FFFF:FFFF::FFFF.
The user may specify an IPv6 address mask for the destination IPv6 address by
ticking the corresponding check box and entering the IPv6 address mask, e.g.
229