Loopback Interface Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
3600000)
Retransmit Time (0-
4294967295)
Hop Limit (0-255)
Managed Flag
Other Configuration
Flag
Min Router AdvInterval
(3-1350)
Max Router AdvInterval
(4-1800)
Click the Apply button to accept the changes made for each individual section.
Click the <<Back button to discard the changes made and return to the previous page.
Click the View All IPv6 Address
Click the View Neighbor Discover
Click the View All IPv6 Address
Click the <<Back button to return to the previous page.
Click the View Neighbor Discover
Click the <<Back button to return to the previous page.

Loopback Interface Settings

This window is used to configure loopback interfaces. A loopback interface is a logical IP interface which is always
active, until a user disables or deletes it. It is independent of the state of any physical interfaces.
To view this window, click Management > IP Interface > Loopback Interfaces Settings, as show below:
after receiving a reachability confirmation, in milliseconds.
Enter the amount of time between retransmissions of router advertisement message
in millisecond, and the router advertisement packet will take it to host.
Enter the default value of the hop limit field in the IPv6 header for packets sent by
hosts that receive this RA message.
Use the drop-down menu to enable or disable the function. When Enabled, it
indicates that hosts receiving this RA must use a stateful address configuration
protocol to obtain an address, in addition to the addresses derived from the
stateless address configuration. Set to Disabled to stop hosts receiving the RA from
using a stateful address configuration to obtain an address.
Use the drop-down menu to enable or disable the function. When Enabled, it
indicates that hosts receiving this RA must use a stateful address configuration
protocol to obtain the address configuration information. Set to Disabled to stop
hosts receiving this RA from using a stateful address configuration protocol to obtain
the address configuration information.
Enter the minimum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 3 seconds
and no greater than .75 * MaxRtrAdvInterval. The default is 0.33 *
MaxRtrAdvInterval.
Enter the maximum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 4 seconds
and no greater than 1800 seconds. The default is 600 seconds.
link to view all the current IPv6 address.
link to view all IPv6 neighbor discover.
link to see the following window.
Figure 3-12 IPv6 Interface Settings – View All IPv6 Address window
link to see the following window.
Figure 3-13 IPv6 Interface Settings – View Neighbor Discover window
38