Lldp Port Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Multiplier (2-10)
LLDP ReInit Delay
(1-10)
LLDP TX Delay
(1-8192)
LLDP Notification
Interval (5-3600)
Click the Apply button to accept the changes made for each individual section.

LLDP Port Settings

On this page the user can configure the LLDP port parameters.
To view the following window, click L2 Features > LLDP > LLDP> LLDP Port Settings, as show below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Notification
Admin Status
advertisements to LLDP neighbors by changing the multiplier used by an LLDP Switch.
When the Time-to-Live for an advertisement expires the advertised data is then deleted
from the neighbor Switch's MIB.
The LLDP re-initialization delay interval is the minimum time that an LLDP port will wait
before reinitializing after receiving an LLDP disable command. To change the LLDP re-
init delay, enter a value between 1 and 10 seconds.
LLDP TX Delay allows the user to change the minimum time delay interval for any
LLDP port which will delay advertising any successive LLDP advertisements due to
change in the LLDP MIB content. To change the LLDP TX Delay, enter a value
between 1 and 8192 seconds.
LLDP Notification Interval is used to send notifications to configured SNMP trap
receiver(s) when an LLDP change is detected in an advertisement received on the port
from an LLDP neighbor. To set the LLDP Notification Interval, enter a value between 5
and 3600 seconds.
Figure 4-102 LLDP Port Settings window
Description
Select the unit you wish to configure.
Use the drop-down menu to select the starting and ending ports to use.
Use the drop-down menu to enable or disable the status of the LLDP notification. This
function controls the SNMP trap however it cannot implement traps on SNMP when the
notification is disabled.
This function controls the local LLDP agent and allows it to send and receive LLDP
frames on the ports. This option contains TX, RX, TX And RX or Disabled.
TX - the local LLDP agent can only transmit LLDP frames.
RX - the local LLDP agent can only receive LLDP frames.
143