V Protocol Vlan Settings - D-Link xStack DGS-3620 Series Reference Manual
Layer 3 managed stackable gigabit switch
Hide thumbs
Also See for xStack DGS-3620 Series:
- Reference manual (1371 pages) ,
- Manual (1170 pages) ,
- Product manual (502 pages)
Table of Contents
Advertisement
®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Protocol Value
Enter a value for the Group. The protocol value is used to identify a protocol of the frame
type specified. The form of the input is 0x0 to 0xffff. Depending on the frame type, the
octet string will have one of the following values: For Ethernet II, this is a 16-bit (2-octet)
hex value. For example, IPv4 is 800, IPv6 is 86dd, ARP is 806, etc. For IEEE802.3 SNAP,
this is a 16-bit (2-octet) hex value. For IEEE802.3 LLC, this is a 2-octet IEEE 802.2 Link
Service Access Point (LSAP) pair. The first octet is for Destination Service Access Point
(DSAP) and the second octet is for Source.
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete Settings button to remove the Protocol for the Protocol VLAN Group information for the specific
entry.
Click the Delete Group button to remove the entry completely.
NOTE: The Group name value should be less than 33 characters.
802.1v Protocol VLAN Settings
The user can configure Protocol VLAN settings. The lower half of the table displays any previously created settings.
To view the following window, click L2 Features > VLAN > 802.1v protocol VLAN > 802.1v Protocol VLAN
Settings, as shown below:
The fields that can be configured are described below:
Parameter
Description
Group ID
Select a previously configured Group ID from the drop-down menu.
Group Name
Select a previously configured Group Name from the drop-down menu.
VID (1-4094)
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user wishes
to create.
VLAN Name
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user wishes
to create.
802.1p Priority
This parameter is specified if you want to re-write the 802.1p default priority previously set
Figure 5-9 802.1v Protocol VLAN Settings window
103
Advertisement
Table of Contents
