System Severity Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
IPv6 Address
Click the Apply button to accept the changes made.
Click the Clear button to clear all the information entered in the fields.

System Severity Settings

The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent. The level at which the
alert triggers either a log entry or a trap message can be set as well. Use the System Severity Settings window to
set the criteria for alerts. The current settings are displayed below the System Severity Table.
To view the following window, click System Configuration > System Log Configuration > System Severity
Settings, as show below:
The fields that can be configured are described below:
Parameter
System Severity
Severity Level
Figure 2-15 System Log & Trap Settings window
Description
Enter the IP interface name used.
Enter the IPv4 address used.
Enter the IPv6 address used.
Figure 2-16 System Severity Settings window
Description
Choose how the alerts are used from the drop-down menu. Select Log to send the alert
of the Severity Type configured to the Switch's log for analysis. Choose Trap to send it
to an SNMP agent for analysis, or select All to send the chosen alert type to an SNMP
agent and the Switch's log for analysis.
This drop-down menu allows you to select the level of messages that will be sent. The
21