Ip Tunnel Gre Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameter
Interface Name
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Edit button to see the following window.
The fields that can be configured are described below:
Parameter
Interface Admin State
Tunnel Mode
IPv6 Address/Prefix
Length
Source IP Address
Destination IP
Address
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made for each individual section.

IP Tunnel GRE Settings

This window is used to configure an existing tunnel as a GRE tunnel (IPv6/IPv4-in-IPv4 or IPv6/IPv4-in-IPv6) on the
Switch. If this tunnel has been configured in another mode before, the tunnel's information will still exist in the
database. However, whether the tunnel's former information is valid or not, it depends on the current mode.
GRE tunnels are simple point-to-point tunnels that can be used within a site or between sites.
When a user wants to configure a GRE IPv6/IPv4-in-IPv4 tunnel, both the source and destination address must be
IPv4 addresses because the delivery protocol is the IPv4 protocol. If the source and destination address type are
not consistent, then the GRE tunnel will not work.
When a user wants to configure a GRE IPv6/IPv4-in-IPv6 tunnel, both the source and destination address must be
IPv6 addresses because the delivery protocol is the IPv6 protocol. If the source and destination address type are
not consistent then the GRE tunnel will not work.
To view the following window, click L3 Features > IP Tunnel > IP Tunnel GRE Settings, as shown below:
Description
Enter the IP tunnel interface name.
Figure 5-9 IP tunnel Settings - Edit window
Description
Use the drop-down menu to enable or disable the interface admin state.
Use the drop-down menu to select the tunnel modes. Available selections are None,
Manual, 6to4, and ISATAP.
Enter the IPv6 network address.
Enter the source IP address.
Enter the destination IP address.
164