Jwac Authentication State; Jwac Customize Page Language - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide

JWAC Authentication State

This window is used to display Japanese Web-based Access Control Host Table information.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Authentication
State as shown below:
The fields that can be configured are described below:
Parameter Description
Port List
Enter a port or range of ports.
Authenticated Tick this check box to only clear authenticated client hosts.
Authenticating Tick this check box to only clear client hosts in the authenticating process.
Blocked Tick this check box to only clear client hosts being temporarily blocked because of the
failure of authentication.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to remove entry based on the port list entered.
Click the View All Hosts button to display all the existing entries.
Click the Clear All Hosts button to remove all the entries listed.

JWAC Customize Page Language

Users can configure JWAC page and language settings for the Switch. The current firmware supports either
English or Japanese.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Customize Page
Language as shown below:
The fields that can be configured are described below:
Parameter
Customize Page Language
Click the Apply button to accept the changes made.
Figure 8-45 JWAC Authentication State Window
Figure 8-46 JWAC Customize Page Language Window
Description
Click the radio buttons to select English or Japanese.
272