Igmp Snooping Multicast Vlan Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Multicast Address List
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Delete button to remove the corresponding entry.

IGMP Snooping Multicast VLAN Settings

On this page the user can configure the IGMP snooping multicast VLAN parameters.
To view the following window, click L2 Features > L2 Multicast Control > Multicast VLAN > IGMP Snooping
Multicast VLAN Settings, as show below:
The fields that can be configured are described below:
Parameter
IGMP Multicast VLAN
State
IGMP Multicast VLAN
Forward Unmatched
IGMP Multicast VLAN
Auto Assign VLAN
VLAN Name
VID (2-4094)
Remap Priority
Replace Priority
Click the Apply button to accept the changes made for each individual section.
Description
Enter the multicast address list value.
Figure 4-79 IGMP Snooping Multicast VLAN Settings window
Description
Click the radio buttons to enable or disable the IGMP Multicast VLAN state.
Click the radio buttons to enable or disable the IGMP Multicast VLAN Forwarding
state.
Specifies to enable or disable the assignment of IGMP control packets to the right
Multicast VLAN. If auto assign VLAN is enabled, the Switch will check for group
matching with multicast VLAN profiles of which the ingress port belongs to. If there
is a match, the result is "in profile" and the matching multicast VLAN will be set as a
packet VLAN. If this function is disabled, the Switch will do VID checking, and
afterwards, if the group does not match the current profile binding, the Switch will
drop this packet.
Enter the VLAN Name used.
Enter the VID used.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default setting
is None.
Tick the check box to specify that the packet's priority will be changed by the
Switch, based on the remap priority. This flag will only take effect when the remap
priority is set.
125