Snmp Host Table Settings; Snmpv6 Host Table Settings - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Priv-Protocol
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

SNMP Host Table Settings

Users can set up SNMP trap recipients for IPv4.
To view the following window, click Management > SNMP Settings > SNMP Host Table Settings, as show below:
The fields that can be configured are described below:
Parameter
Host IP Address
User-based Security
Model
Security Level
Community String /
SNMPv3 User Name
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

SNMPv6 Host Table Settings

Users can set up SNMP trap recipients for IPv6.
only operable when V3 is selected in the SNMP Version field and the Encryption field
has been checked. This field will require the user to enter a password.
SHA – Specify that the HMAC-SHA authentication protocol will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption field
has been checked. This field will require the user to enter a password.
None – Specify that no authorization protocol is in use.
DES – Specify that DES 56-bit encryption is in use, based on the CBC-DES (DES-56)
standard. This field is only operable when V3 is selected in the SNMP Version field
and the Encryption field has been checked. This field will require the user to enter a
password.
Figure 3-44 SNMP Host Table Settings window
Description
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
SNMPv1 – Specify that SNMP version 1 will be used.
SNMPv2 – Specify that SNMP version 2 will be used.
SNMPv3 – Specify that SNMP version 3 will be used.
NoAuthNoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-
NoPriv security level.
AuthNoPriv – To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
AuthPriv – To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
58