D-Link xStack DGS-3420 Series Reference Manual page 46

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
Subnet Mask
VLAN Name
Interface Admin State
Secondary Interface
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Click the IPv4 Edit button to see the following window.
The fields that can be configured are described below:
Parameter
IP MTU (512-1712)
Get IP From
Interface Name
Figure 3-9 IPv4 Interface Settings window
Description
Enter the name of the IP interface being created.
Enter the IPv4 address used.
Enter the IPv4 subnet mask used.
Enter the VLAN Name used.
Use the drop-down menu to enable or disable the Interface Admin State.
Tick the check box to use this Interface as a Secondary Interface. When the primary
IP is not available, the VLAN will switch to the secondary interface. It will switch back
when the primary IP was recovered.
Figure 3-10 IPv4 Interface Settings – Edit window
Description
Enter the IP Layer MTU value used. The value is between 512 and 1712. The default
value is 1500.
Use the drop-down menu to specify the method that this Interface uses to acquire an
IP address.
Enter the name of the IP interface being configured.
36