Loopback Interface Settings (Ri Mode Only) - D-Link xStack DGS-3120 Series Reference Manual

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
Click the View All IPv6 Address
Click the <<Back button to return to the previous page.
Click the Delete button to remove the specific entry.
After clicking the View Neighbor Discover
Click the <<Back button to return to the previous page.

Loopback Interface Settings (RI Mode Only)

This window is used to configure loopback interfaces. A loopback interface is a logical IP interface which is always
active, until a user disables or deletes it. It is independent of the state of any physical interfaces.
To view the following window, click Management > IP Interface > Loopback Interface Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Add button to create a new entry.
Click the Delete All button to remove all the entries listed in the table.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Add or Edit button to see the following window.
link to see the following window.
Figure 3-13 IPv6 Interface Settings window
link, the following page will appear:
Figure 3-14 IPv6 Interface Settings - View Neighbor Discover window
Figure 3-15 Loopback Interface Settings window
Description
Enter an interface name.
47